Clay must not fall into the joint. Seams in the floor and ceiling for ventilation of the hollow space before puttying are sealed insulation (Fig. 22, g). GEA can aid you in your search for knowledge. Outside corner boards. In the formation of an external corner joints cut insulation (Fig. 22, h).

Inside corner boards. In the formation of the internal corner joints cut plasterboard according to Figure 22, and. Facing the wooden obreshetke.Tam where masonry wall is uneven, damaged stucco or frame (Half-timbered houses) and mount boards with glue is not possible, thick drywall rigips 12.5 mm can be mounted on pre-fixed with screws, dowels and wooden crate. First, the wall mounted align the horizontal and vertical wooden slats of thickness of 30-50 mm using dowels and screws (Maximum distance between the dowels 100 cm). Irregularities are compensated for by shims. If at facing the wall to further improve its sound and heat insulation qualities, between the wooden crate on the masonry wall laid mineral wool. Panels are made with screws rigips length of 35 mm at a distance of 25 cm in insulating cladding of external walls to avoid condensation must provide moisture barrier. As a moisture barrier suitable aluminum foil or little wife, who are placed between the insulation and plasterboard Rigips.Svobodno standing facing.

Free-standing coating applies in cases where it is necessary to align an uneven surface or wall mounted concealed wiring in the cavity wall. If both need to improve heat and sound insulation in the cavity wall is placed mineral wool. As the substructure used the C-shaped sections cw 50 or 75 meters, or wooden rack 6×6 cm Fixing the substructure and the veneer is similar to the design partitioning.