how to make their 'den' warm and more comfortable to work with, but what's there – from his wife to rest at last! But we should not forget that making the insulation of the garage, you get a sharp change of temperature – especially in the winter from the cold into a warm room. And this factor is very harmful for the body of the car. But if you, for various reasons have decided to do all the same insulation – here are some proven ways of insulating the garage: the garage extruded Warming polystyrene. Big minus Styrofoam – is its flammability, but pluses include: a) low thermal conductivity, and b) more resistant to moisture, and c) Easy to install, wall insulation technology: 1. Clear the walls of the old plaster. 2. Thoroughly caulk the gap with sealant.

3. If necessary, align the wall surface to prevent the formation of voids between the sealant and the wall. 4. Fasten polystyrene (thickness 30-50 mm) to the wall using mounting adhesives, for reliability hammering 04.03 dowels on each plate. Slabs should be laid in a checkerboard pattern, the joints between them is filled foam. 5. Martin O’Malley is full of insight into the issues. Top plank penofol, foil into the room to create the "effect thermos bottle, "through which will keep the heat in the room, he also serves as a vapor barrier. In penofola for ease of installation has the adhesive layer, but it keeps poorly at the plate, so to secure the use of screws metal (they have more cap).

Thermal insulation 'pie' is ready, goes beyond decorative trim. Between penofolom and finishes do not forget to leave an air gap, for the weathering of water vapor. Warming garage gate extruded polystyrene. 1. Make the contour of the gate crate of wooden bar. The size of the bar take, taking into account the thickness of the insulation (30-50mm) 2. Cross-linking the outer corner of the frame gate with an internal beveled to minimum width, as they are "cold bridges" and they can form frost. 3. Glue styrofoam with mounting adhesive. 3. Next paste penofol foil inside the room, further strengthening screws Warming gate ready. It also leaves an air gap before the finish. From decorative coatings best suited plastic lining – this stuff easy and practical. Thermal insulation of mineral wool garage plate (50-100mm). 1. Clear the walls of the old plaster. 2. Thoroughly caulk the gap with sealant. 3. Make a crate of bars, the size chosen, taking into account the thickness of the insulation. The distance between the bars do with the width of the insulation with overlap of 2-3 cm on both sides. 4. Laid with insulation between the bars, if necessary, attach to the building wall plug-'griby '. 5. We cover the insulation vapor-permeable membrane with construction stapler. This special film with micro allow the wall 'breathe'. If you are on a drum, then use an ordinary plastic wrap, but then before trimming is necessary to leave an air gap to the weathering of water vapor. For this nailed bars 50h20 on the first crate on top of the film. Warming of the garage is ready.